Wiring Base Circuit Board Part: New Google Nest Thermostat

REPLACE YOUR GOOGLE NEST 3rd Generation Learning Thermostat WIRING BASE Circuit Board

Did your Google / Nest wiring base stop working?
This working, replacement part is used to replace YOUR defective circuit board inside your Google / Nest 3rd Gen WIRING BASE mounted on the wall. This part is also often referred to as a "back part" or "wiring harness" or "wiring terminal". This is NOT the part that goes inside the Thermostat itself; rather, this is the wiring base circuit board that hangs on the wall and the thermostat plugs into. This circuit board will NOT work with 1st Gen, 2nd Gen or Thermostat E models. This part is ONLY for ALL Google Nest 3rd Generation model numbers and colors.
It's Easy! Simply take out the 4 screws of YOUR defective wiring base part, remove YOUR defective circuit board, re-use your existing plastic wiring base parts, replace with this new/working circuit board, place back together w/screws, re-mount on your wall and click your thermostat back on. Your thermostat will instantly start working again.
NOTE: PLEASE MAKE SURE YOU FULLY CHARGE YOUR THERMOSTAT WITH A USB CABLE BEFORE INSTALLING AND USING CIRCUIT BOARD PART. A FULL BATTERY CHARGE IS OFTEN REQUIRED IN ORDER FOR THIS NEW PART TO PERFORM A FIRMWARE UPDATE AND CONFIGURE ITSELF WITH YOUR THERMOSTAT. THIS UPDATE/UPGRADE PROCESS TAKES LESS THAN A MINUTE TO ACCOMPLISH AND HAPPENS AUTOMATICALLY BUT A FULL BATTERY CHARGE IS REQUIRED FROM YOUR THERMOSTAT.